- This topic has 1 reply, 2 voices, and was last updated 16 years, 3 months ago by
.
-
Posts
-
Hi all
I have asked a question on this forum before about my Whirlpool (G2P GWI) dishwasher light flashing 3 times. I was told I had to check the heater and the wiring going to the heater incase it was dozed, I have just got round to checking it in the last couple of days – both things seem okay. Put a meter on the heater and it’s reading 25. Read somewhere that it could possibly be the control which reads:
flextronics 220-240 volt, 50-60 hz
WK0309 version 14
UCB-ICFD-P5-A2
Is there any way of testing the circuit board or is it a matter of buying a new one and replacing, if I need to buy a new one – where would be the best place to buy one.Re: whirlpool g2p gwi dishwasher – light flashing 3 times
If you have a similar resistance reading when you meter the heater through the cabling from the pcb end, the only component left is the pcb.
Stick up the 12nc number (The one that starts with 8 ) and we should be able to identify it for you.
Penguin45.
- You must be logged in to reply to this topic.