WIB101

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › WIB101

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • January 25, 2012 at 12:40 pm #67565
    dave-m
    Participant

    Had one of these last week not advancing, brushes were worn, changed them and all good, til now! It gets stuck and will wash all night if let.
    Meggered the motor and heater while there and all good.
    Im thinking its the board but just before i do, am I right in thinking about 20k ohms for the temp cutout?
    I don’t think there’s anything else on it that could cause this.

    cheers

    dave

    January 26, 2012 at 1:16 am #367802
    aqualectric
    Participant

    Re: WIB101

    Check pressure switch (terminals burn regularly but show no external signs)and pump / filter – if not then a PCB programmed from EMW is your best bet.

    Steve.

    January 26, 2012 at 6:30 am #367803
    dave-m
    Participant

    Re: WIB101

    Cheers steve, pump was good and i hung in a new pressure sw too so its gotta be the board.
    No EMW over here too so its the bin i’m afraid.
    However, 8 years out if an Ind&${e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d}#t, with 3 kids aint bad!

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.