wma46

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #13305
    tonyclifton
    Blocked

    hi guys
    got above htpoint, it pumps for 5secs no spin action then 1 min l8 clicks out interlock 😕 changed the motor but still the same any ideas?
    regards
    tony

    #154148
    Goatboy
    Participant

    Re: wma46

    iadom wrote:Hotpoint WMA 30/40/50 Last Error detected codes

    Ensure that the main selector switch is in the Off or O position.

    Press and hold the Super Rinse and Rinse Hold buttons whilst selecting H on the selector knob, and continue to hold for five seconds.

    The ‘Super Rinse’, ‘Rinse Hold’ and ‘Wash’ LED’s will now be flashing.

    Press the Start/Cancel button for two seconds.

    The ‘Rinse Hold’ LED will be lit and the ‘Super Rinse’ LED will be flashing.
    The ‘Final Spin’ LED could be on or off at this stage.

    Press the Rinse Hold button briefly.

    The ‘Rinse Hold’ LED will be flashing & the ‘Super Rinse’ LED will be on steady to indicate the last error routine has been initiated.

    Rotate the main programme selector knob slowly anti-clockwise to programme A

    Slowly rotate the selector switch clockwise through four positions A to D inclusive, pausing briefly at each programme position. Starting with A make a note of the ‘Final Spin’ LED status. it will be on or off.

    When the selector knob reaches D you will have a series of Ons and Offs . This 4 bit binary code should be recorded and checked against the error codes in the following table.

    ……………………………………………………..A………..B………….C………..D

    No spin due to O.O.B……………………….on………off………..off………off

    Start butt pressed with door open…….off……….on…………off……..off
    or O/C interlock.

    Failure to fill in allotted time……………..on……….on……….off……….off

    Failure to pump out in time allowed……off………off………on……….off

    No feedback from thermistor when……off………on……….on………off
    heating.

    Tacho error…………………………………….on……..on……….on………..off

    No feedback from tacho…………………..off……….off………off……….on
    Motor O/C

    Motor triac short circuit…………………….on……….off……….off……….on

    That was a bit of a pain to get lined up but I hope someone may find it useful. 🙂

    I’ve found this info very useful.

    Thank you Iadom :tup:

    #154149
    tonyclifton
    Blocked

    Re: wma46

    sorted cheers goatboy and iadom

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.