Your a genius,if you solve this.BWD129

[pmb]

Hotpoint BWD129
I have had so much trouble with this machine, solve it and you are a genius.
Originally replaced PCB then found power to condenser valve and filling
when power on but not started, caused by shorting in connector plug on PCB,
Replaced Harness to 2 valves.
Current problem
No water to conditioner compartment,
triple valve fitted, one goes to condenser, The other two, both work OK independently but i guess they should both fill together to feed conditioner
compartment and they are not, have tried new valve, EMW have checked PCB-OK, Dispenser top channels look O.K.

[Allsorts]

Re: Your a genius,if you solve this.BWD129

Have you tried looking for a break in a wire, or maybe wired the wrong way around

[helo_75]

its more likely to be an incorrect eprom file
the pcb wont be faulty, but there are several variations of that machine

ive just counted 6 different eprom files on servicenet

[pmb]

Re: Your a genius,if you solve this.BWD129

Yes i have checked wiring
replaced loom to valve, the wire to one valve that that was not replaced i checked several times and fitted new wiring just to be sure,
besides both valves work but not together
interesting about Eprom, I have never fitted one, Allways used EMW
I will ring Tony at EMW tomorrow.

[pmb]

Re: Your a genius,if you solve this.BWD129

Thanks Helo
EMW could not help with a PCB with that programme file
I have replaced alot of PCB to this Model and never had a problem.
The machines in my workshop, put on test wash and dry,few hours later
went to workshop still on dryer, and very hot,the paddles had completely melted, The customer had allready ordered a new machine Im glad to say.

[Author]

Posts