ZAN. zwf14070W

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › ZAN. zwf14070W

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • June 5, 2009 at 3:52 pm #46230
    ddirect
    Participant

    set programme, Door locks,compulsery drain for about three seconds then nothing,no flashing lights to indicate fault code.
    no power to valves. would i be right to suspect main board,or am i missing something simple?
    any thoughts much appreciated,thanks in advance

    June 5, 2009 at 4:06 pm #288633
    Martin
    Participant

    Re: ZAN. zwf14070W

    Assuming you have checked the usual suspects here? Motor? Heater?Pump? etc? ……and a cursory glance at the pcb tracks maybe? 💡

    June 5, 2009 at 4:16 pm #288634
    ddirect
    Participant

    Re: ZAN. zwf14070W

    checked all of the above including glance at pcb tracks, but nothing seems amiss. 😥 😥

    June 5, 2009 at 11:16 pm #288635
    leavemetogetonwithit
    Participant

    Re: ZAN. zwf14070W

    I’d look for condensation around the motor brush holders. If not that then could be a relay on the board not operating.
    Mike.

    June 6, 2009 at 11:28 am #288636
    ddirect
    Participant

    Re: ZAN. zwf14070W

    thanks for suggestions and help. 😀

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.