Zanussi DE6854 Heating Probs

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Zanussi DE6854 Heating Probs

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • October 7, 2006 at 11:12 am #21487
    rootsy
    Participant

    Hello all, could anyone confirm what I have found, in that the heater on my dishwasher when in operation is only recieveing about 90v and that 90v is not constant, it drops down to 0v every couple of seconds. I have concluded that it is a fault within the control PCB as the incoming side of the heater plug has a healthy 230v. I know that it will be suggested that I seek prof help as that is what I suggest in my industry forums!! but if anyone could just tell me that the 90v is not normal I will happily pay £70 for a new PCB. thanks

    October 7, 2006 at 4:13 pm #191090
    Penguin45
    Participant

    Correct. Worth inspecting board for dry joints before replacing.

    Future readers please not that UKWhitegoods does not support or encourage “live” testing.

    Regards,
    Penguin45.

    October 7, 2006 at 4:46 pm #191091
    rootsy
    Participant

    Re: Zanussi DE6854 Heating Probs

    Thank you Penguin45 for the advice, and yes don’t carry out live testing unless you have the skills or are willing to experience a bit of pain!! been there, felt that! 😯

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.