- This topic has 14 replies, 4 voices, and was last updated 10 years, 9 months ago by
.
-
Posts
-
Does anyone know of an alternative part number for a 1327756118 Zan door seal, not recognised on Masterpart web site and can’t find it in the store here. 🙁
TIA.
Jim.
Re: Zanussi door seal
Ta. 🙂
Hmm, not been out to it but customer said it was just a washer not a washer dryer?
Re: Zanussi door seal
It is for a washer, stupid titles weren’t changed for some reason (Dave ;)).
K.
Re: Zanussi door seal
Hi Jim, are you sure it’s a washer dryer door seal.
This washer has a seal fed by a plastic funnel type thing from the drawer to the seal the same shape as a washer dryer air inlet.
Re: Zanussi door seal
Hey Just checked on Electrolux website and this looks like its one of the chinese manufactured machines they were sourcing for a short time and bazza500 is right it got this wierdo funnel thingy and the part number is correct at DST1327756118 not available on the Qualtex or Connect l think the best answer on this one is to give Distri a ring 01325 302 464
Re: Zanussi door seal
Not been out to it yet, it could well be an inlet, possibly similar to the seals on the last British made Hoover washers.
Re: Zanussi door seal
I checked it on the PNC Jim. If that’s right, the seal is right.
If it’s wrong and the PNC is correct, Distri is wrong. If so, that’s a first for me.
K.
Re: Zanussi door seal
It was the correct seal, large water inlet vent at top, not Chinese though.Ffirst one of these I have done, usual rip at the bottom due to trapping clothing in door. :rolls:
Not too bad to do as the front panel comes off quite easily, a bit difficult to get the new seal back on, definitely need a smear of washing up liquid as the concrete weight is very close.
- You must be logged in to reply to this topic.