zanussi IZ12

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › zanussi IZ12

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • July 18, 2010 at 9:22 pm #55913
    Galway
    Participant

    hi called to this and customer said it was stopping in mid cycle.started to run the diagnostics cycle and E61 came up which is a heating fault . element is heating .
    any ideas?
    thanks

    July 19, 2010 at 7:33 am #325569
    Martin
    Participant

    Re: zanussi IZ12

    Galway wrote:any ideas?

    Ohmic value of NTC incorrect? Pressure s/w contacts dodgy?

    July 19, 2010 at 11:22 am #325570
    leavemetogetonwithit
    Participant

    Re: zanussi IZ12

    Had one of these. Was intermittent. Replaced heater relay on main board. Probably RL1, IIRC but should be fairly obvious from following tracks/wiring. Cured.
    Mike.

    July 19, 2010 at 11:46 am #325571
    Galway
    Participant

    Re: zanussi IZ12

    thanks i will have another look

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.