Zanussi ZDC37200w stopping after 10 mins

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Zanussi ZDC37200w stopping after 10 mins

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • December 1, 2014 at 9:22 pm #83248
    tinfish
    Participant

    I’m having a problem with a customer’s tumble dryer. It runs fine, heats up and runs for 10-15 minutes then beeps 3 times and stops. If you switch it off and on again it will run again for 10 minutes.

    I put it in diagnostic mode, but all I got was 3 beeps and 19 red flashes repeating – nothing else flashing that wasn’t on before.

    Any help would be appreciated.

    grant

    December 1, 2014 at 10:28 pm #422206
    lee8
    Participant

    Re: Zanussi ZDC37200w stopping after 10 mins

    E19 code.

    December 2, 2014 at 9:19 am #422207
    tinfish
    Participant

    Re: Zanussi ZDC37200w stopping after 10 mins

    The next question is What is E19? I think I know what E20 is, but I’m positive it was 19 flashes, not 20.

    December 2, 2014 at 10:13 am #422208
    Martin
    Participant

    Re: Zanussi ZDC37200w stopping after 10 mins

    No such error as E19 unless you have it arse about face and E91 being a configuration error. 😉

    December 2, 2014 at 11:39 am #422209
    lee8
    Participant

    Re: Zanussi ZDC37200w stopping after 10 mins

    It’s Electrolux it could be anything not in the manual.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.