Zanussi ZJD12191

[folleyball]

Hi there

I think I’ve lost the plot on this one.

Went to this integrated washer dryer the other day. The dryer wasn’t working. The valve for the dryer was open circuit.
I’ve been back today, fitted the new triple valve. Tested it, and all was fine. When I pushed the machine back in and fitted the integrated door etc, I thought I try it again….

But now what ever programme I try, the machine works for a few seconds then the start/pause button begins to flash.
If I put it on a regular wash programme, it fills normally with the pre wash, the drum turns as normal. It then fills the main wash and then it just stops and the start/pause button flashes.
If I try a spin it empty’s for a few seconds before it stops.
I’ve checked for error codes, but nothing comes up.
Am I missing something obvious. All I have done is replaced the triple valve.
Ready for a few beers me thinks.

[Criscold]

Re: Zanussi ZJD12191

Check the dryer heater, earth faults on these can cause some strange faults.

Enjoy the beer

[folleyball]

Re: Zanussi ZJD12191

Many thanks for the advice.

Went back today. All worked fine until I tried the dryer. Then the same problem arose. Disconnected the element and it’s working fine now. Just to rub it in, the job straight after was the exact same problem – you can’t make it up sometimes!!!

[Author]

Posts