ZANUSSI ZWD1681W

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › ZANUSSI ZWD1681W

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • March 4, 2008 at 1:30 pm #35033
    talkingtent
    Participant

    Can any one help? Zanussi ZWD1681W select wash program door locks fills for approx 20 seconds then start/pause light flashes. No fault code? Is it the PCB?

    March 4, 2008 at 3:56 pm #244884
    Martin
    Participant

    Re: ZANUSSI ZWD1681W

    talkingtent wrote:Is it the PCB?

    What have you checked so far?….. Heater? Motor? NTC? etc… etc… 😕

    It’s unwise to assume the PCB has failed until all other options are at least checked out. 😉

    March 4, 2008 at 5:08 pm #244885
    talkingtent
    Participant

    Re: ZANUSSI ZWD1681W

    Spin cycle is ok. (Induction motor) I was hoping for a simple test program any ideas ? I will check other parts tomorrow at the customers house.

    March 7, 2008 at 11:46 am #244886
    talkingtent
    Participant

    Re: ZANUSSI ZWD1681W

    Just a note dryer heater down to earth. That was the fault.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.