[16vmini]

thanks dave ,

After checking the board i found scorch marks under the Fuse (F1) i “attempted” to replace this to run a test , but as you might know , it was something else on the board causing the fuse to blow big time !! , anyways i spent no more time on it trying to figure out what on board is causing it ( coil/transformer ? ) and ended up buying a new board from espares , arrived just now and fitted , and washing machine working again …

[16vmini]

i know i should start a new post , but thought fellow BEKO owners could help here ,, been googling , i had d7 issue as posted before and all be fine for months , now House mains tripped other day when wife put it onto a drying cycle , reset mains trip , then washer powered on fine , started drying cycle and could hear it draining .. so far so good , then NO spining , motor does not turn , like its getting no power..

I see there is a sperate driver board for the motor ? does anyone have any tips to check , i put meter on motor when running drying cycle , i do not seem to get any voltage .

[16vmini]

Thanks for this thread ( and any other site that was the source etc ) I had exact same issue , , machine dead , tested D7 like people said , 0 both ways on meter, had trouble ordering with RS links etc ,so got my 10 pack of diodes from :

https://www.switchelectronics.co.uk/products/sb2100-schottky-rectifier-diode-2a-100v-pack-of-10

ordered Sunday, posted monday , received Tuesday and fitted, all good £5.83 all in

[Author]

Posts