[aanda]

andybond wrote:Hi, I have the same F2 problem – I have the part but not sure how to fix.

To remove the old sensor, does it pull off from the cable or does the cable have to be cut? i.e do i just cut cables and use the QUICKON-ONE union nut to connect the existing cable to the cable with the new sensor (so that the union nut stays in the fridge – I cant see how else this would work but imagine it would look a bit odd). Instructions also state QUICKON-ONE connection must not be in the interior of the appliance which I dont see – how can it not be in the interior?

Or is the sensor somehow removed from the cable and the old cable attached to the new sensor??

Sorry if I’m being a bit stupid. Any advice welcomed.

Hi,
I got a bit frustrated by it!…
(Restrictions where that I could not remove the sensor from either the new or the old, and that I could not remove the connector from the old sensor once unlugged from the pcb.)
I removed the whole cable (after taking enough screws off the back of the fridge to be able to remove the cable, but without doing any damage…top two either side, and then the next one down on the right near the hole from the compartment).
The display pannel easily unclips (but gently), and it is the green plug from the pcb that I dealt with).
I then cut the old plug off the faulty cable (giving myself about 1 foot to spare) and wired the new sensor to the old plug just behind the pcb.
Result…working fridge with no unsightly connectors, but a bit of a hastle at the time!
I’ll never win an award for clear English, but hope this makes sence?!!
I was happy to take this risk, but acknowledged that I might need to spend a lot more if I got it wrong…good luck.

[aanda]

Re: Liebherr f2 fault

Thank you! Would this fault also explain why our fan at the back doesnt work? It hasn’t been working for a while now, but we just ignored it as at the time, the fridge seemed to be working ok.

[aanda]

Re: Liebherr f2 fault

Thank you very much for your reply.

I can not see anything on the right hand side or corner matching your description.

THe only location I can see where anything may be hiding is on the LEFT hand side located just to the rear of the light…is this what you are talking about?
Can you please confirm that the below part number is correct as it is not one mentioned in other forums on this website with what seems to be similar faults?

Thank you

Regards

Andrew

[Author]

Posts