[Alty09]

Re: Samsung SR2229CVW Defrost problem….

Hi, again,

It seems it’s still having defrost problems, as the fridge fan keeps freezing up, twice since last post, so seeing as the readings were apparently normal! any ideas?

If it is a defrost sensor would it be logical to replace the fridge one first and are they the same as it has one for each side?

Thanks

Leon

[Alty09]

Hi, weird! but since doing all the tests on Weds and putting it all back together it has worked since then!?!

Freezer = -18
Fridge = 3

No variations at all, food is freezing and Ice Maker is working as it should be.

Any Ideas what went/going on ?

Thanks

Leon

[Alty09]

Re: Samsung SR2229CVW Defrost problem….

OK, managed to get hold of a Mastech Meter and quickly checked the following in the Freezer section:

Freezer Side

Top:
Thermal Fuse for continuity = OK (Well the meter beeps)

Middle:
Main Heater = 263Ω
Drain Heater = 2.13 KΩ

Bottom:
Defrost Sensor = 14 KΩ (fluctuates to just below)

and the fan in the freezer is working.

The White Sensor (Blue wires & behind the blue cover) is showing as just over 5 K at room temperature and goes down when you warm it up.

The readings were taken with the evaporator covered in ice, just defrosting now then will check again.

So would it confirm that it is the Main Defrost heater as suggested by Bryan ? or….?

Going to check the Fridge side later. [Done. see below.]

I used the information from the “A rough guide to the Samsung RS21 fridge freezer problems” as a guide so don’t know if the values are the same for our Samsung but seem to be, except for the Main Defrost Heater! ?

Top: This is the Thermal Fuse simply test for continuity

Middle: This is the defrost heater connection and the resistance values should read:
Main Heater = 480Ω
Drain Heater = 2KΩ

Bottom: Is the NTC Defrost Sensor which should read 13.3 K ohms @ 0oC (This value will change depending on the temperature!)

Addendum 15.25pm

Just checked the sensors again now there is no ice on it at all.

Freezer Side.

Top:
Thermal Fuse for continuity = OK (Well the meter beeps)

Middle:
Main Heater = 263Ω
Drain Heater = 2.13 KΩ

Bottom:
Defrost Sensor = 10.3 KΩ [Just 15.40pm gave the evaporator a quick blast with a hair dryer and the Defrost Sensor went down to 5 KΩ, as it says in the article it is variable, does this mean it’s working as it should be?]

So all the same except for the Defrost Sensor or is the difference within any tolerances?

Fridge Side.

Top:
Thermal Fuse for continuity = OK (Well the meter beeps)

Middle:
Main Heater = 585Ω <<< ?
Drain Heater = 2.13 KΩ

Bottom:
Defrost Sensor = 11 KΩ

Thanks

Leon

[Alty09]

Re: Samsung SR2229CVW Defrost problem….

Hi Bryan,

What would I need to do that and what is the proper procedure?

Many thanks.

Leon

p.s. Funny how you get used to things, it’s been so long now, do we even need a freezer….Yeeeeees from screams of children….Ice Cream, Ice Cream… : )

[Alty09]

Re: Samsung SR2229CVW Defrost problem….

Hi Bryan,

Thanks for the pointer, which one would you suggest replacing first ? or both and from what I’ve seen these are both end user replacements, but correct me if I’m wrong.

Leon

[Alty09]

Re: Samsung SR2229CVW Defrost problem….

Just an update to let anyone know, the Freezer is now at 8 and went down to 6 yesterday so it’s fluctuating slightly and the half bottle in the top bottom drawer is still frozen?

So still baffled and waiting to spend money on some parts that will let us buy more food.

Not had chance to check fan, daughter has only just finished moving into Halls, which I am going to do now.

Thanks.

[Alty09]

Re: Samsung SR2229CVW Defrost problem….

Thanks for the replies and sorry for delay in getting back but eldest daughter is moving to Uni and, yes I’ve turned into Dad Transport ; )

I just went to check the condenser fan and it wasn’t actually turning but did start up again after I checked what spimps asked me to check, it is turning freely by hand and doesn’t feel loose in it’s bearings (a little play but wouldn’t say it’s really worn).

I haven’t had time to check the (freezer) fan but will do later tonight or tomorrow, just to let you know I did take out the top sensor (The one that says ‘Temperature Sensor’) to take it to a shop that sent me a wrong one for comparison and when I took it out the temp on the front panel went quickly to temp set, then after putting it back in it’s stayed at the temp set but flashes. (Addendum: After resetting the FF the temp on the freezer panel now shows a stable 7°)

Also my wife put a half bottle (500ml) of water in the bottom draw to see if it would freeze as the bottom of the freezer is cold and although it took a couple of days it has frozen?

Luckily the fridge is still working as we’d be up the creek without a paddle as there are 7 people in the house and it’s the most important appliance in the house, so all suggestions are appreciated.

🙂

[Alty09]

Re: Samsung SR2229CVW Defrost problem….

Not one of the 32 viewers got any ideas?

[Author]

Posts