Andy Hopkins

Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)

Author

Posts
July 20, 2021 at 9:00 am in reply to: Spin cycle start/stop after motor replacement #478021

Andy Hopkins
Participant

There was an error code of e08. I will upload a picture of the original motor as it is easy to hand, the new one is in the machine so a bit more difficult.

https://ibb.co/pdQKT8F
https://ibb.co/n0vcKK9
https://ibb.co/HD2q7VC
https://ibb.co/tb0VTVC

July 19, 2021 at 3:45 pm in reply to: Spin cycle start/stop after motor replacement #478018

Andy Hopkins
Participant

That sounds like I have the correct motor in that case, the question is, is it the motor that is causing the issue that I am experiencing?

Thanks
Author

Posts

Viewing 2 posts - 1 through 2 (of 2 total)