[baldmechanic]

Re: hotpoint Aquarius WF250 Problem

on further investigation i removed the pcb board, and on inspection i can see burn or overheat damage on the board, so looks like the pcb is up the spout, the cost of these boards is stupid money, so looks like the machine gonna have to go to scrapyard in the sky 🙁

[baldmechanic]

Re: hotpoint Aquarius WF250 Problem

Ok ta, was hoping it not 🙁 one thing tho after removing rear inspection plate and checking the wires and contacts, tried machine again and same thing happened, but the growling and vibration comes from pump at lower corner, rear of machine, have checked it is not seized at all.

[Author]

Posts