[bamforp]

Re: John Lewis JLDWS1202 Not Drying

Hi – yes, I’ve opened the door mid-cycle a couple of times to check the water is hot. It’s hard to tell if it’s as hot as it should be though. Could it be related to a UTC fault?

[bamforp]

Re: John Lewis JLDWS1202 Not Heating

Matrix was full of crud so I removed it and gave it a good clean out. Still coming up with the same error. I read the post about perhaps needing a new matrix but the fact the drain fault only started after I ‘fixed’ the solder joint makes me wonder if the control board is faulty – perhaps I damaged it whilst repairing the relay joint? Time to call in a professional I think.

[bamforp]

Re: John Lewis JLDWS1202 Not Heating

Thanks for the quick reply Penguin. There was indeed a bad joint under the relay which I have repaired. Unfortunately there is now a new error! After a couple of drain cycles it beeps twice repeatedly which according to the user guide is an outflow problem. I have tried putting some water in the sump and this is cleared easily so I don’t think it’s a blockage problem. I have also checked the pressure switch which appears clear so it brings me back to the sensor which I assume plays a part in sensing an empty sump. Is there any way to test the sensor or at least eliminate it as the source of the problem?

Thanks

[Author]

Posts