Forum Replies Created
-
Posts
-
Re: hotpoint ultimer condenser,TDC 60- help needed
yes thats the peg i mean m8
i guess it must be the PCB.
i used to play 5-aside football with a lad who was an engineer 5 years ago so i’ll try get his number & see if he can sort it.
thanx once again for all your help m8 😉Re: hotpoint ultimer condenser,TDC 60- help needed
thanx again 4 that mate i will have a look 😉
another thing i found out 2day is i tryed it again for around 10 minutes because i had a feeling that the themostats had gone now.
sowhen it stopped after 10 minutes i went 2 open the door but i did’nt push it hard enough toopen it & the dryer started again 😯 it ran for a few minutes then stopped again so i just tapped the door lightly & away it went again, i done this 5 times 😯 but it was’nt heating so the thermostats have gone. i had a look at the lock inside & it was a bit slack so i tightened it then noticed a plastic pin in the middle top of the door that goes in2 a little hole & behind is somesort of switch, is this a microswitch of somesort & could this be the cause? i put it back 2 gether & tryed it again it done the same thing twice over then dry light went out & it did’nt do it again until the dry light came back on.
while i had it all open thistime i checked all wires to see if any were loose but all fine.
thanx bill.Re: hotpoint ultimer condenser,TDC 60- help needed
point taken 🙁
oh well we will just have 2 wait until we can get it sorted.
thanx bill.Re: hotpoint ultimer condenser,TDC 60- help needed
much appreciated for the quick replies lads, i did try it again but it just did two dry spins and two reverse spins and stopped again.
looks like its time to get a couple of free quotes done, was hopeing it was something i could fix myself as monies a bit tight but hey ho such is life.
thanks again,
bill.
