[bluerobin]

Re: Beko CDA648FS/1 Frost Free Fridge Freezer-Fridge is Froz

jskelton555 wrote:just replaced my fridge sensor on Beko CDA648 F/F. Not a hard job- cut insulation away a bit at a time, sensor is 50mm + deep so there is a fair bit to cut out. sensor sits in a tube on back wall. mine was 220mm down from top and 200mm from left side. i poked another hole to PCB board and soldered connections back on. finally I put a carefully sized piece of kingspan insulation in the neat rectangular hole I cut in back. Hole was 60mm deep 100mm wide.
all is now fine
hope this helps
regards
john 😀
forgot to say lots of step by step photos, just don’t know where to load them

PM for further info if you are stuck!
Hi,Could you send me photos of what you did please to fit the sensor ? Kind Regards Mark

[Author]

Posts