[BobBoulby]

Re: Bosch Logixx 7 WIS24140GB Wash & Rinse Hold Flashing Lig

Ok, I’ve removed cover at the bottom right hand side and it was clear inside. There is an impeller at the back of the housing which will rotate in either direction but in 90 degree “notches” – is this normal?

I’ve put the machine through a rinse and pump out and it was ok although the pump is making a sort of throbbing noise (presumably when there is no water left). Is this normal?

I’m not sure if I should just leave it or call an engineer under the warranty.

Thanks again – Bob

[BobBoulby]

Re: Bosch Logixx 7 WIS24140GB Wash & Rinse Hold Flashing Lig

Now that’s embarrassing, I’m not used to manuals being quite so informative 😳

Thanks for your help.

Bob

[BobBoulby]

Re: Help Please – De Dietrich VZ9996U1 Not Rinsing Properly

Thanks everyone for your feedback.

I’ll try upping the salt dosage slightly (I’m pretty sure that we are not in one of the hard water areas of Yorkshire) and I’ll also give Fairy Tabs a try.

I still have a doubt at the back of my mind though around the fact that the rinse aid doesn’t seem to be getting used up. Still if there is a rinse aid dispenser problem presumably the Fairy Tabs will compensate for this.

Thanks again – Bob

[BobBoulby]

Re: Help Please – De Dietrich VZ9996U1 Not Rinsing Properly

We live in West Yorkshire and according to the Yorkshire Water web site the average total hardness in our area is 35 mg Ca/l (max 45mg Ca/l). The film is opaque rather than white.

I’ll take on board what you said about Glist. The problem started when I was using Morrison’s own brand tablets (and own brand rinse aid), but I’d been using these without problem for several years.

Bob

[BobBoulby]

Re: Help Please – De Dietrich VZ9996U1 Not Rinsing Properly

Thanks Clive.

The coating is fairly uniform but I have already done as you suggest and let the salt run out and not re-filled it. Unfortunately this hasn’t make any difference. The Glist tablets I’m using at the moment are 3-in-1 but I’m still getting the deposit (although maybe not quite as bad).

Bob

[BobBoulby]

Re: Help Please – De Dietrich VZ9996U1 Not Rinsing Properly

If this is the gasket on the lid you remove to top-up the rinse dispenser, then it’s in good condition.

Bob

[BobBoulby]

Re: Help Please – De Dietrich VZ9996U1 Not Rinsing Properly

Is this something I can check myself?

Bob

[BobBoulby]

Re: Help Please – De Dietrich VZ9996U1 Not Rinsing Properly

Hi Dave and thanks for your quick reply.

I’ve been using the same Morrison’s own brand tablets for ages and the rinse problem has only started in the last few weeks. I tried switching to Glist but it’s not made any difference.

Bob

[Author]

Posts