[Breadsnapper]

Re: Tangential Fan

The fan was replaced as it wasn’t working because the plastic housing for the spade connector had broken which in turn had broken the wire on the coil and wasn’t fixable. The element is being replaced as when I took it out to inspect it there was a split in it.
It seems that some sensor or other thinks the oven is hot even when it is cold.

[Breadsnapper]

Re: Tangential Fan

Ok this is becoming a pain. So far I have fitted a new tangential fan. When the cooker is switched on at the mains the fan starts. No matter how long I leave it the thing continues to run. The fan control sensor which is located with 2 screws on the back of some ducting. If I disconnect to 2 blue wires connected to it then the fan doesn’t run. I have also discovered that the round fan oven element is not working. I have ordered a new element and fan sensor. Would I need to replace the other thermostat sensor too or is that just for oven temp?

[Breadsnapper]

Re: Tangential Fan

So a faulty stat will cause the fan to continua run? Are the polar specific by chance?

[Breadsnapper]

Re: Smeg suk61mfx wiring

The oven selector has been removed from the cooker I’ve just bought. I have a new selector but need to know which wire goes where as there isn’t a wiring guide in the selector. I haven’t disconnected any of the gas pipes just removed the hob top.
Cheers.

[Author]

Posts