Britoven1

Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • October 3, 2019 at 1:27 pm in reply to: Temperature selector switch – melted leads #463469
    Britoven1
    Participant

    Ah… thanks. Good idea – at least to have in back pocket. I think there will be enough room as connector is on top and there is room above.
    Many thanks

    October 3, 2019 at 1:03 pm in reply to: Temperature selector switch – melted leads #463467
    Britoven1
    Participant

    Many thanks Dave
    The original connectors had a insulation sleeve as per the photo (I’ve turned the black connector upside down so I could see what connector is needed). You can see the melted sleeve on the blue. Do I need to replace the sleeve? Which is why I was thinking of using the fully insulated connector.
    Note: 2 wires going into the connector – presumably the connector crimp can handle that.
    Thanks for all your help so far.


    October 3, 2019 at 7:16 am in reply to: Temperature selector switch – melted leads #463465
    Britoven1
    Participant

    Many thanks Dave
    Very helpful and especially for the advice on crimping.
    I’m hoping there will be a bit of ‘give’ in the blue wires to allow me to cut and replace the crimp without replacing the wires completely.

    Can I fit a universal type crimp connector such as this one: https://shop.ukwhitegoods.co.uk/3051182-blue-faston-connector
    Or do I need something particular? (Forgot to check at weekend when oven was dismantled and won’t be able to check before weekend)

    Anything else I need to be aware of?

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)