[chrisbly]

Re: Candy CNA135-80 wont stop spinning

Thank you for the reply.

The motor runs smooth when I had the cover off and no arcing even during the ramp up to full spin speed. I can not see any water stains on the motor. The filter trap was clear and I had stripped down the pump and hoses.
It does drain correctly but seems not to advance the timer from the spin cycle in any of the programs. If I advance the timer manualy past the spin it will go through one more fast spin and then turn off like it should and release the door lock.

Could it be linked to the element going down to earth? I have read this some postings.

The one thing I don’t understand is how does the WM now when to stop spinning, is there any sensor system? water level, motor torque monitoring or is it solely program timer based?

[Author]

Posts