[cnelsonplumber]

Re: FIDW41 problem

I have mis-diagnosed this a little.

the machine is throwing the trip mid programme on B and C settings now. Something happens after the wash cycle but I need to sit and watch it to see exactly what is going on when it trips, wish I had time for that.

Something to do with the rinse possibly

[cnelsonplumber]

Re: FIDW41 problem

Thanks Martin.

I am running the machine this morning to see if it cuts out at the same dial setting every time.

So far it has gone through the A and B programmes, which are the pot settings, no problem but seems to trip on the C programme.

Just trying to figure out what goes on during the light wash (C) programme that doesn’t happen during the longer washes.

Temp is 65C throughout so still scratching my head 😕

I think I can borrow a tester but not sure what to do with it, might be an extension to my learning curve.

[cnelsonplumber]

Re: FIDW41 problem

Replaced the heater, but unfortunately the dishwasher is still blowing the main RCD mid cycle.

Heater is good.

The pump seems ok as it runs early on in cycle.

No leaks on to electrics.

Can anyone suggest where to look for the problem next pls?

[cnelsonplumber]

Re: FIDW41 problem

Thanks for the tip.

I have removed the heater, which was reasonably straight forward as the hoses and clips are in good condition. 😮

The heater is visually in good shape, but I would like to test it before replacement in case the fault lies elsewhere. :rolls:

Is this something I can test with my trusty multi-meter or will I require a professional appliance tester. :eeek:

[cnelsonplumber]

Re: FIDW41 problem

Having removed the dish washer from it’s comfy built in spot I can now have a good look at it.

Before I carry out any surgery, thought it might be a good idea to get some expert advice on where the heater is and the best way to get at it without removing any necessary lumps.

I have quite a good space to work in and can turn the machine upside down now that all the water is completely gone.

If anyone has any tips on other maintenance to carry out while it is in bits that would be great also.

This is going to be a bit of a journey which I will be grateful to share!!!

[cnelsonplumber]

Re: FIDW41 problem

Thank you all.

Just seen the heating element on flea bay for £22 😀

It looks like a take it out and turn it upside down sort of a job, 😕 so will test at the weekend.

[Author]

Posts