[colink2]

Thanks for the update.

I might end up buying another oven as there are too many uncertainties about dimensions which might be difficult to sort out online. If I coul dwalk into a store with the motor it might be easier.

ColinK

[colink2]

electrofix wrote:its the shaft length that set these apart plus the tail for the rear cooling fan

dont know of anything else that will fit

Dave

Thanks for your reply – even though it is bad news.

It would be a shame to dump the whole oven for one part.

I am fairly capable of modifying things, including extending a shaft by welding.

If you have any suggestions for anything that might work (possibly without a rear fan) please let me know.

Can you confirm that a 2 wire motor should work with the third wire left off. The oven heats with all 3 wires disconnected, so I assume it would work with 2?
Or maybe with a fan connected in parallel with the heating elements?

My mum is currently using only the top oven, but a bit difficult for her to reach.

If the fan opening in lower oven was blocked off, how inefficient might the bottom oven be?

Colin K

[colink2]

[USER=”4209″]electrofix[/USER]

Do you or anyone else still have one of these motors. Your photo for Unifit s9 is exactly what I need.

Oven is a Creda Corniche 43992

Looking in this thread it seems the following part numbers may be compatible “ELE3559” OR “C00233779” OR “MT068”

If this is not available can you or anyone advise if there is anything compatible, that possibly needs wiring modified.

Original has 3 wires + earth
Most motors online seem to be 2 wires

Would a 2 wire motor work by not connecting third wire, or joining that wire to one of the other two?

The other difference from motors I see online are the length of the shaft.

If necessary I could arrange to weld part of old shaft to a new motor.

If I could find anything that would work with my oven and 3 wire system, even with some modifications needed would be much cheaper than replacing the oven

[Author]

Posts