[CR33DO]

Re: HOTPOINT WMA36s – door lock light flashing – UPDATE

That answers my next question.

How sure can I be that it was the door module that blew the main board?
What if there is another fault that i cannot see and i blow 100 pounds of parts up in smoke as soon as i put them back in.

It sounds like the Hotpoint engineer will be a good route to take at this time. Is the 99pound offer available through Hotpoint direct or is this an offer through a 3rd party?

Thanks for all the information guys!

Regards,

Nick.

[CR33DO]

Re: HOTPOINT WMA36s – door lock light flashing – UPDATE

Thanks Jim,

I will email in the morning.
Looks like fitting shouldn`t be too much hassle either.

Regards,

Nick

[CR33DO]

Re: HOTPOINT WMA36s – door lock light flashing

Back again,

Bad news, blown circuit board!
I first noticed burn marks on the back of the program selector, then saw 2 burnt out tracks in the corresponding position on the main board.

Any ideas how to proceed? Are the boards an economical repair, or it it time for a new machine?

Nick.

[CR33DO]

Re: HOTPOINT WMA36s – door lock light flashing

Thankyou for the quick reply.

Off to do that now.

Will post result.

Nick.

[Author]

Posts