[Cujik]

Re: AEG lavamat turbo 16830, not drying clothes

So I’ve got the machine all together again and I’m doing a load of drying, everything seems to be working and when I started the programme it said 115 mins to go but the time is now saying 30 mins and it’s only been 20 mins since I started it!! Water is leaving the machine into the drain also, so the steam must be condensing I assume..

[Cujik]

Re: AEG lavamat turbo 16830, not drying clothes

Hi lee8,

Yes, the water is passing through the valve across the back of the machine and down into the condenser tank. The valve doesn’t permanently feed water but I think that’s correct.

[Cujik]

Re: AEG lavamat turbo 16830, not drying clothes

Hi folks,

So after my first replies I have followed up by testing both the elements which are both better than 500 Mohms, to earth, the fan and ducts are operating very well” I bypassed the door to check this” the heating elements are both working. I’ve also tested the solenoid valve for the drying cycle and it’s fine? Why am I still getting intermittent e10 faults and damp hot clothes? Hope someone can help.. 🙂

[Cujik]

Re: AEG lavamat turbo 16830, not drying clothes

Hi, thanks for the fast reply, yes the solenoid valve is passing a steady flow at intervals throughout the cycle, the fan is running well and the duct after the fan is getting hot, I have not checked the heater element but do have an insulation tester so can give it a try, the clothes are getting very hot when the e10 stays away but they are still damp…

[Author]

Posts