davyboy212

Forum Replies Created

Viewing 5 posts - 1 through 5 (of 5 total)

Author

Posts
February 23, 2008 at 10:39 am in reply to: Hotpoint Ultima FDW80 Fault code displayed AL01 #243585

davyboy212
Participant

Re: Hotpoint Ultima FDW80 Fault code displayed AL01

al05 = circulation pump fault

February 21, 2008 at 11:07 am in reply to: Hotpoint Ultima FDW80 Fault code displayed AL01 #243577

davyboy212
Participant

Re: Hotpoint Ultima FDW80 Fault code displayed AL01

its been switched off for a couple of days, when i switched it on and started a program i got al05, now its gone back to al01

February 18, 2008 at 7:11 pm in reply to: Hotpoint Ultima FDW80 Fault code displayed AL01 #243572

davyboy212
Participant

Re: Hotpoint Ultima FDW80 Fault code displayed AL01

no just al01

February 18, 2008 at 6:49 pm in reply to: Hotpoint Ultima FDW80 Fault code displayed AL01 #243570

davyboy212
Participant

Re: Hotpoint Ultima FDW80 Fault code displayed AL01

Hi jim

I held the button but i do not hear any beeps.

February 18, 2008 at 5:47 pm in reply to: Hotpoint Ultima FDW80 Fault code displayed AL01 #243568

davyboy212
Participant

Re: Hotpoint Ultima FDW80 Fault code displayed AL01

Hi Jim.

The wiring to the switch is certainly fine. I was wondering about the board but wanted to find out from other techs more experienced on Hotpoint than me.

Incidently, it was put onto Demo & the fault code came up then too. Just thought I’d mention it in case it gave any further clues.

Cheers.
Author

Posts

Viewing 5 posts - 1 through 5 (of 5 total)