Forum Replies Created
-
Posts
-
Re: Recommends for a new machine
LOL , how do I stop the bloomin bleepin when it stops?
Tried the volume but can’t make it work.
DbD
Re: Recommends for a new machine
Thanx to penguin & Don.
Got the Bosch WAE24162 , which seemed to have a slighlty slower spin rate.
Got in currys , bloke told me it was only 1 year garuantee , but I bought it anyway.
Imagine my delight when I saw the 2 yr free on the front 😀 .Lovely , that gives me 2 yrs to stow £10 / mth in a savings account and if it should go wrong after that I have the money.
SELF INSURANCE , the only way imho. 8)
Thanx once again chaps.
£249 by the way.
DbD :waving:
Re: Indesit W143s – Dial clicks round, light flashes 10 time
Great info,
Thanx for all the help.DbD :waving:
Re: Indesit W143s – Dial clicks round, light flashes 10 time
Cheers Jack,
I notice that the eprom doesn’t come with the module does this need to be replaced as well when replacing module?DbD
Re: Indesit W143s – Dial clicks round, light flashes 10 time
Penguin45 wrote:That one’s defo the computer board – sorry.
Penguin45.So when you say computer board , are we talking the module?
http://www.4indesit.co.uk/cgi-bin/produ … path=52691
Also intrigued by the bank of 5 contacts which are accesible from the back of the machine .
A testing connection?
DbD
Re: Indesit W143s – Dial clicks round, light flashes 10 time
We don’t want you to have it that easy . 😆
Seriously though most of us always tile under the appliances .
Wish you lot would make longer hoses and not put the cable through a teeny hole THEN put the plug on. 😆
Cheers for the advice anyways.
DbD
Re: Indesit W143s – Dial clicks round, light flashes 10 time
Hi all,
This is wierd , I usually answer all questions regarding wall & floor tiling on other forums.Anyways , great site firstly 🙂
I have exactly the same fault as the original poster , with an extra bit of detail.
Set the washer ( W143 ) to say 4 , light flashes to show its in mode , then the water valve at the back seems to open momentarily , letting in a couple of dribbles , then after about 10 seconds it goes into drain out mode ( which it does on every other setting as well.
Sometimes it just goes straight to drain out mode.
So if it is the pressure switch , where is it?
Is it worth cleaning out the inlet valves out ( although they seem to be clear ).
Cheers
DbD
