[desmarbilsam]

Re: BEKO WM6167W

Sorry. That should read “Pump” and NOT “Pimp” lol

[desmarbilsam]

Re: Hotpoint Aquarius WMA46 – Machine switching itself off

Thanks Iadom
Is the Tacho a part that can be replaced or does it come as an integral part of the motor? I have looked on various spares websites (including this one) but haven’t been able to find it anywhere

[desmarbilsam]

Re: Hotpoint Aquarius WF541 Temperature Control

Hi Allsorts
I’ve checked the control knob and it appears to be fine. Turns and clicks as normal. Even removed the switch itself from the board to check it and it appears fine (no broken contacts). Cleaned all the contacts on the pcb in case there wsh a dirty connection and put the machine through a cycle again to see if it made a difference. Now it is doing all sorts of weird and wonderful things!!!! I put it on a drain cycle and it filled with water and did a complete wash cycle. Tried to end the cycle by pressing and holding the cancel button. All lights lit and then stopped …. momenterily before continuing on it’s wash cycle. Even turned it off using the on/off switch and about 4 seconds later..the machine turned itself back on and continued with the wash cycle. It’s now as though it has a mind of it’s own and it does it’s own thing!!!!!!

[desmarbilsam]

Re: Hotpoint Aquarius WF541 Temperature Control

lol 🙂 Thanks for the advise. Much appreciated

[desmarbilsam]

Re: Hotpoint Aquarius WF541 Temperature Control

Thanks very much for this advise. Just 1 question about your reply. When you refer to the “Module”, are you referring to the main PCB at the back of the machine? It sounds like an expense I could well do without on the run up to xmas 🙁

[desmarbilsam]

Re: Hotpoint Aquarius WF541 Temperature Control

Thanks IADOM. Most helpful. Is the control switch on the Control PCB replaceable or would I need to purchase the whole PCB?

[Author]

Posts