[diyplumb]

Re: Bosch not taking in enough water

Thanks Clive,

will try checks tomorrow – is replacing the aquastop device an option, and is it a straightforward job assuming the part is available

thanks again

[diyplumb]

Re: Bosch not taking in enough water

Hi again folks 🙂

This same bosch dishwasher is lasting well, but now it has a new problem, wanted to check if there are any fixes or tests to try out before I look into a new dishwasher.

I cleaned out the pipe as previously described but the problem seems to be that water is getting into the machine very slowly. It will eventually fill and do the wash…etc but it takes hours to finish the complete cycle.

with the side panel on left removed, I can see the incoming water rate is very slow,
. I suspect it is related to the aquastop device.

any suggestions gratefully received

thanks 🙂

[diyplumb]

Re: Bosch SMI 2022 – wiring problem/replacement?

Ok thanks Iadom – clearer now 🙂

I’d forgotten about how difficult accessing the bottom part of this machine was (had to clear a blockage a few years ago – see post http://www.ukwhitegoods.co.uk/modules.p … highlight= ).

As the machine will have to come out anyway – I’ll take a closer look at the underside – not so sure my wife will be keen on letting me try to fix it 😉

Thanks again for all the help – much appreciated

[diyplumb]

Re: Bosch SMI 2022 – wiring problem/replacement?

Hi again Iadom,

many thanks for this info.

just two more questions to help me decide if a replacement attempt is worthwhile or whether a new machine is called for 🙂

– Could you give some pointers to what makes this a tricky/difficult job
– any recommendations as to where I could obtain this part (can’t see it on the whitegoods shop)

Many thanks again

[diyplumb]

Re: Bosch SMI 2022 – wiring problem/replacement?

Hi Iadom,

many thanks for the quick reply 🙂

I see the following number on the dishwasher:

E-NR.SMI2022GB/03

Is that the one you were asking for ?

Thanks again

[Author]

Posts