[DomX]

Re: Blomberg 1501AAA Motor drive problem

Machine is at least 3 years old – possibly 5 – not sure, sorry.
But certainly old enough that would replace rather than do too much replacing of bits.

There is no speed control module as such as I see it (unless this is the bit on the end of motor). So it would be the entire control PCB with the sequence switches.

I guess am mainly asking those with experience if it is known for high voltage to arc across motor cables/connector in to low-voltage sense cables. This would give me confidence that cause rectified now that have cleaned up.

Thanks for quick response.

[Author]

Posts