[Elkejk]

Inlet valve not problem- I connect mains direct to inlet valve. Water start ruin. Flow meter roll.

Now measured exact: Select program (any) —> start/stop-button —> 180 second and start/stop + ready start blink. Drain pump stop in this fault. Nothing after this.

– All programs
– Plug off and then test again- no effect, same fault
– “Reset” it is press start/stop – then rotate program switch- wait, this reset program- no effect, same fault
– Drain pump voltage 235 VAC
– Drain pump pump, but no difference is sump filled or not- same fault
– This is all what happened: Drain pump run 180 second, but this is all. Inlet valve not operate, it is, all what happened is this 180 second drain pump operate. So, dishwasher not start take water. Also measured: Inlet valve no power, it is, I connect voltage meter parallel with inlet valve- 180 second drain pump, inlet valve never operate.

Problem is, I cannot find any sensor measure this “sump is empty, stop pumping”. Cannot find just this machine manual, but any service manual near this model. This manual looks just same as machine I try fix- only difference is manual contain power switch, my model not. This manual does not “speak” any sensor for “sump empty”. So I cannot know how this “sump level” regognized.

Manual:
https://www.manualslib.com/manual/873406/Vestel-Dishwasher.html

Exact error is “End + start/pause blink”. The waste warter cannot in the machine cannot be discharged. Water discharge hose is clogged (unpossible, inside machine no water). The filters of your machine might be clogged. (Not, cleaned.) Power off you machine and activate program cancellation command. (Yes, tested this many, many, many times, also power off plugged-off.) if error continues, contact the service. (Yes, typically I buy pre-owned devices and fix it… but sometimes I must put thumb to mouth, second thumb to other place, and change…) .

So… error is very mysterious. It looks “inside machine is any hidden sump sensor. It measure waste water is pumped away. But this sensor is broken.”

[Author]

Posts