[FernWood]

Re: Bosch SGS45E08GB – Help

Hi,

I have read some of the posts on here, and decided to have a go myself. I have managed to open the case and have a look, and the pressure chamber was full of gunk, including the hose that runs from that to under the dishwasher.

I have emptied the dishwasher out, cleaned the hoses and pressure chamber and reconnected, but while the machine starts the cycle it only runs to 36 mins and wont empty.

Apart from taking the pump cover off and checking the impeller (I am guessing this the little water paddle under the compartment where you remove the torx screw), and checking the connection to under the sink is there anything else I could try.

I have read someone mention a one way valve or rubber flap, but I am not sure what this really is? I have also noticed that in the long plastic chamber on the LHS of the machine, there is water about half way up the 1st tube – might this suggest a blockage?

I have also tried a reset and cannot hear the pump trying to drain, but this may be that it is not engaging due to some other reason that the pump being broke?

[FernWood]

Re: Bosch SGS45E08GB

Hi,

From the outside it sounds like a humming noise, and when you open the door usually the dishwasher stops, but when the fault occurs it keeps going and sounds like water sloshing around inside (presumably the pump?), although there is never any water in the dishwasher.

Are there some simple checks I can do to try and see what the problem is.

Thanks in advance.

[Author]

Posts