[flyingscot]

Good luck. I hope it lasts. I had touched up some poor looking joints previously but don’t think I worked properly… The issue with intermittent faults.
I got a technician out to help and they replaced the main PCB then running an earth leakage test before signing off the job found it surprisingly high. Next they changed the heater element and it was either that or remaking all the connections that finally fixed the machine. Not as conclusive as I was hoping in terms of identifying the cause but I’m back up and running nicely.

[flyingscot]

OK, so I really need the right manual to find where the safety relays are. 1 on the main PCB and maybe 1 on the front control panel? There’s a Dutch guy who repairs the PCB for this error for 60 EUR. That’s less than half the cost of a new board form AEG/Electrolux but a heck of a lot for a small relay -but he knows which of the four to change!

[flyingscot]

OK, I found the ENV06 service manual that covers my machine (I think -how do I check?). https://www.4mcculloch.co.uk/images/mediator/553/599709900.pdf
Anyway EHE = Incongruence between the safety relay (main board) and safety “sensing” circuit. Test to be performed… Replace the main board and restart the diagnostic cycle to check for further alarms.
So that’s no real help.

[flyingscot]

Well I finally worked out the diagnostic mode. Turn to C1 with delay+pause for 5s. Anyway, C10 holds the errors I think and it reported EHE and then I cleared it to E00 by pressing delay. Which seal might have gone?
Thanks.

[Author]

Posts