[gardnecd]

Re: Bosh SGS5002GB/07 Poor Spray Pressure

Thanks.
Insufficient filling is my problem.
Simple test of course – just didnt think of it.
Just added a jug-full of water after it had finished filling and bags of pressure!
Probably just muck in the pipework somewhere then. I like that. A lot cheaper 🙂
Colin

[gardnecd]

Re: Bosch SGS43A loss of spray pressure

Penguin45 wrote:Blockage in the hose from the fill matrix to the sump. Many, many posts on the subject. Net result, underfilling. Remove plug, outer door panel, kick panel and inner lower cover plate. Offending hose is in left hand corner. Remove, clean, replace.

Regards,
Penguin45.

I will give that a go this evening – can do no harm – but the fill level seems to be fine. Water is covering the base of the machine – so lots of water in the sump. That was one of my intial lines of investigation so I removed and cleaned up the “pressure chamber” which appears to be what regulates the water level.

BTW if it turns out to be the heater/flow divertor thing as mentioned in one of the other replies (which appears to be all one unit) how much £ we talking?
product ID: SGS43A52GB/35

And how easy/hard to replace – looks hard!

RGDS

Colin

[Author]

Posts