Forum Replies Created
-
AuthorPosts
-
gazr600
ParticipantRe: samsung washer fault code 1e
check pressure hose where it goes on to pressure switch it probably has a small hole which cause it to think pressure switch has dropped water level cut off about 15mm and refit
gazr600
ParticipantRe: samsung srs2026cvw
hi mate check thermal fuse and heater assembly in fridge section when either go open circuit appliance runs to temp then shuts down if you find thermal fuse open cicuit you need to change sensor as defrost was to long hope this helps
gazr600
ParticipantRe: Schreiber APM 6855 fridge freezer
sounds like defrost problem probably defost sensor but heaters and thermal fuses would need to be checked what postcode i will probably know an engineer in that area
gazr600
ParticipantRe: Expert Appliance Care
I to am with EAC and the sad thing is the engineers that are going to give it a go on there own seem to be being told unless you do laundry we are not that interested so if there are any ins / agents who require the services of highly skilled engineers in various postcodes pm me and i will supply details this is just a group off what i think are top qaulity engineers wanting to earn a living so bfore we lose these skilled people lets give them some work and the chance of earning a living after the way they have been treated lets not lose there skill
gazr600
ParticipantRe: It’s getting cold, or is it?
i am one of these pm me for location thanks 15 yrs exp and devotion gone in 30 seconds
February 23, 2006 at 1:06 pm in reply to: SAMSUNG RS21DCSV1/XEU recurring fault or not fixed? #158972gazr600
ParticipantRe: SAMSUNG RS21DCSV1/XEU recurring fault or not fixed?
Hi ALL
The problem is due to a faulty fridge evaporator sensor or evaporator heater in fridge section being open circuitgazr600
ParticipantRe: Samsung SR-S20
Hi ALL
maybe i can help the main cause for this problem is component failure normally the heater in the fridge or the thermal fuse go open cicuit causing ice to build within weeks of defrosting also the plenheims can become pourous causing them to freeze new plenheim req or evaporator defrost sensor goes out of calibration preventing defrosts all above may require a service call -
AuthorPosts
