[Gazza1701]

Re: prima lpr600 beeping, but not starting – please help!

Hi Dave
Removed old rubber hose, carefully cut off the moulded rubber on the pump housing, fitted a 1 cm length of 25 mm hose on the sprinkler moulding and then pushed a 5 cm length of 32 mm hose on top of it and onto the pump housing. Both ends held in place with a jubilee clip. Hope that makes sense. Works a treat. Definitely not paying £100.
Garry.

[Gazza1701]

Re: prima lpr600 beeping, but not starting – please help!

Problem Found. Small hole in hose from pump to sprinkler rotor arms, also lots of cuts in my fingers!! 😆

[Gazza1701]

Re: prima lpr600 beeping, but not starting – please help!

Me Again
Have remover front cover to expose pump Etc and found that the bottom tray is full of water, about 1 cm deep. no immediate sign of where it has come from.

[Gazza1701]

Re: prima lpr600 beeping, but not starting – please help!

Hi Dave
No blockage, put water in machine and it pumps out fine, pump goes on for 4-5 mins then flashes the f4 error code. does it have a float orpressure switch to know when it is empty?
Regards Garry

[Gazza1701]

Re: prima lpr600 beeping, but not starting – please help!

I Have the same problem, Starts to pump out, keeps pumping for 4-5 mins then beeps continiously an wash setting goes back to rinse.
Did spot the power light flash 4 times then pause.
Any one have any thoughts?

[Author]

Posts