[gerards]

Penguin45 wrote:The logic is flawless. Check continuity from the pcb to dispenser to be doubly sure. If ok, pcb it is. For info, it’s usually the actuator which blows the pcb – cause and effect thing going on.

Penguin45.

Thanks for the reply,
Continuity from the pcb to dispenser checks out OK. I have since opened the control module to look for any signs of PCB damage but all looks OK, but without any circuit information its difficult to know what’s going on. I assume it can now only be the control module at fault ?. Where is the best place to obtain spares.

Thanks once again for your assistance.

[Author]

Posts