[Gerry85]

Re: WD71 – Control PCB replaced…now NEW error E30

Did you check the motor brushes on the spare motor you fitted?!

[Gerry85]

Re: Bosch tumble dryer completely turning off while drying

Try pluging the dryer into a differant plug socket.

[Gerry85]

Re: FDW60 making horrible clicking/tapping/hammering nose

Sounds like a piece of glass is rattling around in the circulating motor or in the drain pump. Most likely the circ motor by the way your describing it.

[Gerry85]

Re: Bosch SBV69U80EU/01 Not filling properly

Max,

Assuming you have checked the obvious
-water supply
-mesh filter at end of fill hose
-kinked inlet hose ( hard to kink on the bosch il admit)
-waste hose not siphoning water

I would go with replacing that reed switch at the flow meter. Usually it will put up an E 14 error code if my memory serves me correctly.
The main pcb’s tend to be fairly reliable and I have never replaced one for a water inlet fault. But in saying that every day is a school day.

Another thing to check if your dishwasher has the plastic bottom, is that there is no water leaking into the base activating the anti-flood. ( this caught me out before). You will see evidance of leaking from where the plastic base meets the metal case.

Hope this helps u out.
G

[Author]

Posts