[gjutla]

Re: Zanussi ZRB227W0 Fridge Freezer Problem

HI
inspect and secure all wiring connections as you might have disturbed them during defrosting.It happened to me but it was a different model.Good Luck

[gjutla]

Re: beko fridge/freezer Model CDA539FW-2

HI Kwatt
Fridge is now working after moving about the little cylinder shaped sensor behind the freezer cover.I suspect it is faulty.But according to the DRAWINGS on the website the sensor supplied has only 2 wires and the one fitted has 4 wires .I guess it is a modification but the pics are quite blurry and the colour of the wires cant be seen.Is it possiable to elaborate before I order the part
Thanks

[gjutla]

Re: beko fridge/freezer Model CDA539FW-2

Hi again,
I would like to have further help with the above fridge/freezer.I managed to open the back of the freezer compartment and I found 2 control devices.one of them is a thermal fuse and the other is a small cylinder shaped device which I guess is a sensor.But I do not understand if this sensor actually controls the temperature of the fridge which is freezing or if there is another sensor behind the fridge compartment which is not accessable.
Thanks again

[gjutla]

Re: beko fridge/freezer Model CDA539FW-2

Ok Thanks.Do you know how to replace this sensor or where is it located?
Thanks again

[gjutla]

Re: beko fridge/freezer Model CDA539FW-2

Hi
Thanks for the post.Sorry about mentioning resistor.I think it must be the sortof Thermister or sensor which sends a signal SWITCH OFF (open-circuit) to the control pcb board after reaching a set temperature by us inside the fridge.The control pcb board then switch off the compresser.Obviously it has to be done by 2 wires leading to control pcb board from the sensor.My question is still the same.Which are those 2 wires on the control pcb board?
Thanks and any further help will be appreciated.

[Author]

Posts