[Gregga1000]

Hi Dave

I have attached the pnc number below. There is a sensor that sits in the sump. I have cleaned around it just incase of a build up of limescale etc.

To add. The machine started faulting by only beeping once and the bottom of the machine was full of water (not drained). Once reset the pump would run and drain and usually run a full cycle ok.

PNC 911 539 205 00
Seriel 90925114
Typ GHE623DA2

Thanks

[Gregga1000]

Update

On closer inspection the two overflow pipes that are draining water into the tray seem to be exactly that. They are attached to small drains under the door.

My question is now what tells the board when enough water has been loaded into the machine? I can’t see a level sensor anywhere.
Is there a workshop manual available anywhere other than the operation manual I have downloaded from Manuals lip?

Many thanks

[Author]

Posts