[grimalkin]

Re: siemens wash and dry 6140 (E-NR WD614000GB/13FD7705)

cheers for all the help ,one last question ,as this machine was in my house when i bought the place ,how old could this wash and dry 6140 be ?
thanks and have a good xmass .

[grimalkin]

Re: siemens wash and dry 6140 (E-NR WD614000GB/13FD7705)

did not take too long to chuck it again ,checked them valves and they have all tested ok for continuity/resistance (tested straight after fault came on) 🙁 is it poss that the main cold valve is worn/sticking/weak causing the flow prob ? when it is on a cold cycle the flow when looking through the detergant drawer is weak/low ,watched it on a final rinse and it was flooding through compared to the start of a cold wash , are the valves all set for different flow rates ?

[grimalkin]

evening nomadpaul after checking the hot _cold water intake i popped off the top cover and with the PLUG OUT checked each valve electrical connector was tight i removed each one in turn and reconnected them now the machine is working ok so yes a valve defo seems to be faulty will wait till it chucks it again and check them for resistance as advised <many thanks for your help < one thing the mrs has noticed tonight is that there is water in the middle compartment of the detergent tray <it must fill and drain into the machine via a overflow type arrangement <is this the softner compartment ?

[grimalkin]

Re: siemens wash and dry 6140 (E-NR WD614000GB/13FD7705)

ok carried out test as directed ,surprise surprise your spot on ,the machine stops on a cold wash (15 wool ) and goes into a wash no probs on a 90 ,when it stops it shows a 3 as per fault ,got the powder tray out and checked for blockages ,all seems clear ,removed cold intake and tested for water pressure ,more than enough presssure/flow ,there is a bank/group of 4 intake valves on the cold side , looking down on them from front of machine there is a yellow top left a grey top right a blue bottom left and a biege bottom right ,there are 3 outlets ,one goes to the dryer side (blue ) biege to the intake tray and yellow to intake tray,the hot water is a lone red valve adjacent on the left , anything else worth checking ? or is it a case of new valve bank/cluster ? you mention a gauze ? is this on the intake side ?

[grimalkin]

Re: siemens wash and dry 6140 (E-NR WD614000GB/13FD7705)

thanks for the reply nomadpaul ….was wondering about the brown vacum type switch unit ,(clicks 3 times when sucked ) which is connected to the lower rear of the drum (blown down pipe and is clear/no resistence ),dont know what it is called ! the intake valve /valves do not as far as i am aware sound like they are energizing prior to the fault showing but low water sounds good ,will get another check to confirm water intake as advised and get back to you tomorrow .
cheers

[grimalkin]

Re: siemens wash and dry 6140 (E-NR WD614000GB/13FD7705)

so just a quick recap : machine intermittantly stops before final rinse , the number 3 is displayed in the drying time red display with a flashing dot ,the yellow anti crease light flashes ,switch it off at the main dial ,go to final rinse and away she goes ,its a bit of a pest cause it means we cant do a wash when out ,with 3 kids in the house the dam thing is never off ,dont have a manual so need a we bit of advice ,even a hint on the fault code would help …

[grimalkin]

Re: siemens wash and dry 6140 (E-NR WD614000GB/13FD7705)

when the error code 3 shows in the red display the yellow anticrease light is also flashing ,any ideas ?

[Author]

Posts