[haventaclue]

Whatever else,make sure those damm pink wires are IN the drain hole and not under the drip tray

[haventaclue]

I’m getting 2.13 on the 20K ohm scale but the video I watched is looking 485 but doesn’t say what scale he is using.
I have continuity on the fuse and the temp. sensor decreases ohms as it gets warmer and increases as it get colder,held it in my hand and stuck it in a cup of ice.
So would I be correct in assuming the heater is US? Any replies would be greatly appreciated?

[haventaclue]

Ok bit the bullet and pulled it apart,again.And it’s all frosted up again.New temperature sensor,yellow wires and white end,new evaporator cover,from this site,whitegoods.co.uk.,and I’m wondering where I go from here.
I’m waiting or it to defrost so as I can test the defrost thermal fuse.I did test before and it was good,on the assumption that if I test at the connector and get continuity between the black and red wires,it’s good.I’ll also test the temp. sensor as well.
Anyone tell me what ohms I should get on the defrost heating element please?

[Author]

Posts