Forum Replies Created
-
Posts
-
Re: Bosch SGS4302 – not heating up and stuck on 1 minute
Again, thanks to Penguin45 and ProgRob, mine turned out to be a dry solder joint on the pcb, but only after testing everything else (typically). All works like new again, saved me a small fortune, thanks. If anybody wants info for the pcb repair, my symptoms were 1 minute remaining, cold water (i.e. not heating during cycle), but would pump out if reset (1st and 3rd buttons from LEFT). I am happy to provide full walkthrough if you pm me. – basically POWER OFF ! – remove all screws around door from inside (T20) – remove display cover (2 screws and 2 flexible tabs, lift up and off) – remove screw from right hand side of door (edge) – note, or photo cabels and remove – pop out pcb module – look for dry joint (it will stand out like a sore thumb) resolder and reverse dismantle procedure. Turn on and test, water should get warm ! 😀
