[ib2130]

Re: Question regarding bearings on Hotpoint Ultima WT960G.

Hi – blimey, you start early 😀

Thanks again , I’ll need to order another new bearing before fitting the seal as I damaged it when removing it.

Other than that do you think it will be okay with that water drain hole blocked by the bearing ? There again I guess it lasted 5yrs on the first set okay …

[ib2130]

Re: Question regarding bearings on Hotpoint Ultima WT960G.

Thanks for your help, here is a pic I took of the new one yesterday before I removed it to check depth etc,

I can refit again tomorrow after work and also fit seal and post that pic too if it helps ?

[ib2130]

Re: Question regarding bearings on Hotpoint Ultima WT960G.

Hi, I wish I could but the old ones fell apart and went straight in the bin when I dismantled it. Only thing I can tell you is the part code of the new ones are C00202418 which are the 35mm kit.

I always have this sort of luck 😀

[ib2130]

Re: Question regarding bearings on Hotpoint Ultima WT960G.

Hi iadom, thanks for the reply. I thought the same, even thought I may have some dirt trapped behind it stopping it seating properly so I knocked the new one back out to check and I measured it and the bearing with seal is 3mm deeper than the depth of the sleeve.

Also the position of the drain hole is bugging me as the bearing covers it, in all the other images I’ve seen of it the hole sits above the bearing where the seal would sit. Here’s a picture of my sleeve.

Not sure whether to order another bearing kit to try…

[Author]

Posts