iggie

Forum Replies Created

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • in reply to: Creda ‘Cachet’ Solarplus; Only one oven will work #259173
    iggie
    Participant

    Re: Creda ‘Cachet’ Solarplus; Only one oven will work

    Many thank Penguin, emailed tonight & i’ll let you know what happens…..hopefully it’ll result in us being able to go there for sunday roasts again in the near future!! 😀

    in reply to: Creda ‘Cachet’ Solarplus; Only one oven will work #259171
    iggie
    Participant

    Re: Creda ‘Cachet’ Solarplus; Only one oven will work

    Ok, fortunately I had the presence of mind to anticipate the next question!!
    Both thermostats are working as they ought, a good draught is coming from the fan (Although…excuse possible extreme stupidity here, but in which direction should the cooling fan blow? at present, it blows from its location top back out towards the front, and not much actually passes then down the door fronts; surely it would be better if it drew air in and therefore upwards through the doors?…prepares for incoming 😳 ).
    The oven is about 14 months old, and has adequate ventilation from below through plinth vent & is clear at the rear…
    Would it be worth just changing the thermal cut out anyway? Any idea of part cost?

    Cheers

    igz

    in reply to: Creda ‘Cachet’ Solarplus; Only one oven will work #259169
    iggie
    Participant

    Re: Creda ‘Cachet’ Solarplus; Only one oven will work

    Ok then, upon turning on either oven, or the grill, the cooling fan immediatley starts up. Does this help?!!

    in reply to: Creda ‘Cachet’ Solarplus; Only one oven will work #259168
    iggie
    Participant

    Re: Creda ‘Cachet’ Solarplus; Only one oven will work

    Thanks Penguin45, I’ll call in there tomorrow & check, and report back!

    Regards

    in reply to: Creda ‘Cachet’ Solarplus; Only one oven will work #259166
    iggie
    Participant

    Re: Creda ‘Cachet’ Solarplus; Only one oven will work

    My apologies for the delay in replying! The model number is 48181.
    As far as I am aware, if either oven is used in isolation, then all is well, but if both ovens are run together, then when they reach temperature, both cut out, and will not work again until the whole unit has cooled totally….sounds very much as though there is a thermal cut out mis-behaving, but could see no sign of one when replacing lower oven element (which I incorrectly diagnosed as being faulty….)

Viewing 5 posts - 1 through 5 (of 5 total)