[jackwest]

Re: Fisher & Paykel GW608U won’t start cycle

Thanks for the quick reply Penguin45.

I could blow air through the clear plastic tube attached to the motor control board, it seems to be clear, it’s hard to tell being such a small diameter tube and not knowing what’s on the other end of it.

When I went back into diagnostic mode the water solenoids and drain pump are now operating normally, ie not just for 1-2 secs, but the cycle still doesn’t start. I’m hoping this isn’t getting to odd for you.

Below is a complete readout in diagnostic mode, just in case it can give some clues.

0000 – 0000 0000
0001 – 0000 0000
0010 – 0000 0000
0011 – 0000 1011

0100 – 0100 0010
0101 – 0000 0111
0110 – 0000 1101
0111 – 0000 0001

1000 – 0001 0011
1001 – 0000 0111
1010 – 0000 1101
1011 – 1111 1111

1100 – 0000 0001* (*flashing)
1101 – 0010 0100
1110 – 0100 0110
1111 – 0001 0100

Appreciate for your help so far,
Jack

[Author]

Posts