Forum Replies Created
-
Posts
-
Re: Bosch SL15K1B shows flashing active light but will not s
Perhaps no user function, but in this case, pressed with the “official” reset, it caused led to flicker and a reset(full reset rather than partial ?. Prior to that the “official” reset on its own did nothing. This extra switch is mounted on the board physically and electrically connected and oddly, Bosch have even installed the white remote operating paddle. I have asked Bosch for a view but all may be a little academic as the 10 year model is hardly main stream.
The image is of the panel disconnected. The Start/Stop button partially falls back until panel is properly mounted.
With all that said it could be down to a flaky connector being made good with the moving. However giving the panel a gentle thump and shake did not indicate that. I’ll settle for serendipity.
Bosch SG143E05GB reset after 3 secs fails
Raised this a day ago with your appliance master where it was concluded the control board was faulty and about £100 total to replace. Took a second look by taking off the control panel, springing off the SS panel with its surrounding bezel, temporarly re-fitting the metal assembly that holds the control module, closing the door. Noted there was a second switch beside the “reset” switch but this does not show when normally fully assembled. Turned power on at socket and pressed both switches together(the program dial position at OFF) and hey presto the machine came back to life. Machine has run correctly since and I’ve still got my £100 !Above is an image of the SS panel as normaly seen. Below it is the control module hidden behind. Arrows showing the second switch(2).
NOTE WELL: there is mains within the exposed control box so only press the two plastic levers that drive the switches.Re: Bosch SL15K1B shows flashing active light but will not s
Loooked at cost so last question : How certain is it the control module ? Is there any service available that could verify the suspect control module is faulty ?
Re: Bosch SL15K1B shows flashing active light but will not s
Thank you.Most helpful. I have looked at the board no obvious signs of major component failure(brown resistors, blown capacitors or melted tracks). Can you advise on good source for these boards ?
Re: Bosch SL15K1B shows flashing active light but will not s
I suspect the same but would being uncertain how the logic on the board works I would like to verify if the Aquastop valve is working. Is there a particular way ? other than pull it out, hose wiring white connector block and all then put a meter across it ?
Re: Bosch SL15K1B shows flashing active light but will not s
No. But pump will run when you lift the internal float ?
