[jimyorks]

Re: Servis washer M3024 Spin Cycle, wont speed up

Thank you for your excellent help, the problem is now resolved but leaves me a little embarrassed. 😳

During sourcing a new Control Module/pcb as suggested (Part number 546028802 – 0230) I discovered it would not spin if it had no load in the drum. How it knows i have no idea, but putting a few more items in the drum cured the problem.

This also resolved the problem of the belt coming off in the first place. The motor mounting bolt had worn very loose destrying a rubber mounting bush (there is only 1 bolt holding this motor in) causing the motor to suffer massive vibration, and the rear retaining bar had bent leaving the motor shaft out of line with the pulley.

Just one question. Is this rear retaining bar supposed to be straight?

Again, Thank you for your help, It sent me in the direction to find the solution.
Jim

[jimyorks]

Re: Servis washer M3024 Spin Cycle, wont speed up

Thank you for your quick reply, i was in the right area and was dreading it to be the circuit board/control module. (expensive)

Could the drum belt coming off have caused this because what i can find out from my other half it happened just after this?

I was hoping there would be a reset button or something – dreaming helps sometimes. 🙂
Thanks for your help

[Author]

Posts